K-10
PISTON
TYPE BACK PRESSURE VALVE
APPLICATIONS:
For water, other liquids, and fuel oils of all grades. Not for
steam. Designed to limit a specific pump discharge pressure on
machine tool hydraulic systems, oil burning equipment, rams, presses,
lifts, etc.
SIZES: 1/4", 3/8",1/2",3/4",1",1-1/4"
FEATURES:
Bronze
angle body, stainless steel trim, threaded connections, single
metal-to-metal seat only, bottom female inlet, side female outlet.
Relief pressure ranges from 15 to 600 psi. Maximum temperature
is 450°F (232°C).
FOR
MORE INFORMATION, WRITE OR CALL
FOR BULLETIN
BPV-K .
K-15
HIGH PRESSURE,
ANGLE BYPASS VALVE
APPLICATIONS:
Suited
for bypass applications on high pressure pumps or any system requiring
automatic regulation of pump discharge pressure. Many applications
in the chemical and process field (waste treatment-desalination)
and car washes.
SIZES: 1/4", 3/8", 1/2", 3/4"
FEATURES:
Angle
type bypass valve handles high pressure up to 1500 psi in brass
body. Threaded connections. Maximum temperature 450°F (232°C).
OPTIONS:
Employs a replaceable stainless steel seat and piston for
longer valve life at minimal cost. Does not have to be removed
from the line for servicing.
FOR MORE INFORMATION, WRITE OR CALL
FOR BULLETIN BPV-K.
KP
PILOT OPERATED
BACK PRESSURE VALVE
APPLICATIONS:
Suitable for
air or water service.
SIZES: 1",1-1/4",1-1/2",2"
FEATURES:
Offers high-capacity, extremely accurate control. Main valve features
brass construction, Buna-N diaphragm and seat disc, stainless
steel spring. Pilot is brass with stainless steel spring, seat
disc and seat ring; bronze diaphragms for air service or neoprene
diaphragms for water. Pressure setting 15 to 200 psi.
OPTIONS:
Available with modifications for high temperature (to 400°F
[204°C]), high pressure (to 400 psi) and low temperatures
(to -320°F [ -196°C]).
FOR MORE INFORMATION, WRITE OR CALL
FOR BULLETIN BPV-KP.
MC
SMALL BYPASS
VALVE
APPLICATIONS:
For water,
air, oil, and other fluids.
SIZES: 1/2", 3/4", 1"
FEATURES:
Small, economical bypass valve for pressure control of a less-critical
nature. Bronze body, stainless steel
ball seat. Metal to metal seat - does not close off drip tight.
Leak-proof cover cap and gasket. Male inlet, female side outlet.
Pressure ranges 10 to 250 psi.
FOR MORE INFORMATION, WRITE OR CALL
FOR BULLETIN.
NSW
ADJUSTABLE
ANGLE BYPASS VALVE
APPLICATIONS:
An inexpensive
solution to installations requiring frequent changes in the set
point. Designed for bypass and over-pressure protection in pumping
systems such as weed sprayers, etc. that are non-corrosive to
bronze.
SIZES: 1/2" only
FEATURES:
Bronze body, Buna-N disc and stainless steel spring. One of three
pressure springs is used, providing an adjustable range of 10
to 60 Ibs., 0 to 125 Ibs., or 20 to 200 Ibs. Male inlet, female
outlet.
FOR MORE INFORMATION, WRITE OR CALL
FOR BULLETIN.
